How can we choose so many self - clinching studs To get what you want?

 How can we choose so many self - clinching studs To get what you want?

Here's how to choose. To understand the reliability of the reputation of rivet manufacturers, you can understand through the Internet or industry personnel, understand whether there is controversy in rivet manufacturers, how much negative news. self - clinching studs  manufacturers usually choose large manufacturers, reliability and strength, indicating that the quality must be better than small manufacturers. But on the contrary, small factories want to survive, seize the quality is normal, even worse than the big factories, even worse than the big factories, so in terms of choice, I suggest running. If you do not know the rivet market and you want to rivet, I suggest you can find a dedicated staff to follow, one is to prevent wasting money and can understand together. That's what your editor told you. Based on the above information, you should know how to choose a riveting stud manufacturer. Generally speaking, low price is not very good, and high price and good quality are also very high, so I suggest you choose quality standards, price and cost-effective pressure riveting stud manufacturers.

Pressure rivet nuts, also known as self-tightening nuts, are suitable for metal plates or nuts. They are round and have convex teeth and guide grooves at one end. The principle is to press preset holes into the metal plate through embossing teeth. In general, the diameter of the preset hole is slightly smaller than the diameter of the rivet nut's convex teeth. The convex teeth of the rivet nut produce pressure plastic deformation around the preset hole and the deformation is pressed into the guide groove to produce a locking effect. Technical guide for installation and use of riveted nuts. ? Rivet nuts series 1, S are made of free cutting cast iron, heat treated, property treated, CLS series are made of free cutting stainless steel, the surface is not treated. Figure 2. Low carbon steel plate hardness must be less than 70Rb, stainless steel plate hardness must be less than 80Rb. 3, suitable for all kinds of thickness of the plate, small thickness of 0.8mm, when using must be according to the thickness of the plate and nut specifications, determine the corresponding plate tail size Z, according to the thickness of the plate according to the table sample order. 4. Accurate control according to the size of the hole. According to the tolerance of 0-+ 0.075mm size processing, that is, punching, the nut should be generally installed in the plate "section" of the installation process, usually using the "self - clinching studs " way, never the way of impact.