Installation method and advantages of riveting nut

Method and advantages of mounting riveted nuts to provide load-bearing threads on metal plates-for aluminum, cold-rolled steel, and other ductile materials. Rivet nut installation schematic diagram, the use of standard fixtures, easy to install: Rivet nut installation is simple, fast and convenient. Simply press the rivet nut into the pre-perforated or drilled mounting hole to install a certain force to facilitate pressing the rivet nut embedded in the mounting version. Rivet nut installation tension, High push-out force and Torque: Rivet nut position and metal plate closely Mesh, ensure the product has a strong push-out force. At the same time, the perfect combination of the product teeth and the metal plate ensures the product to achieve a higher anti-torsion output. Rivet nut installation diagram, non-destructive installation: The recommended product handle length is always less than the minimum thickness of the mounting plate, under the appropriate installation force, the rivet nut in the screw is neither deformed nor easily damaged. Pressure Rivet nut installation schematic diagram, flat back: Pressure Rivet nut from the installation plate to complete the installation, installation plate back flat smooth. Rivet Nut Installation Diagram, anti-loosening pressure rivet nut, this type of rivet nut has a unique internal thread design, can be used for higher occasions anti-loosening performance requirements. Apply to stainless steel plate pressure rivet nut, this product uses special stainless steel material, and then heat treatment, so that most of the 300 series stainless steel plate to achieve high hardness. This feature makes the rivet nut more suitable for mounting on stainless steel plates. (1) in order to avoid product deformation and optimize product performance, the distance from the hole center to the edge of the mounting plate should be as close as possible or higher than the standard value. (2) the corresponding punching diameter of the mounting hole shall be within + . 001/. 025 mm. The fist must remain sharp. Fasteners shall be mounted in the same direction as the holes.