self- clinching nuts Manufacturers share the considerations for using polyethylene self-Clinching Nuts

Self-clinching Nuts Manufacturers share the precautions for using polyethylene self-Clinching Nuts

Widely used in shipbuilding, vehicle, aviation, electrical, appearance, metal cabinet, elevator and other industries plate connection, easy to operate, stable connection, beautiful appearance, low power consumption, high efficiency. The deformation of rivet nut is similar to that of simple parts or complex parts. Since the rivet nut deforms at both ends under axial pressure, the stress is better than that of a simple part or pipe bulging under radial pressure. After riveting, the length of the rivet nut is shortened, and its length is related to the plasticity and size of the material. Below, tasman Area rivet nut manufacturer shares what you should know when using Pham rivet nut.

Before starting, a small amount of lubricating oil is injected into the air inlet to ensure the performance and service life of the rivet nut gun. Maintain normal intake pressure. If the pressure is too low, it will reduce the power of the rivet hammer. Not only the efficiency of rivet is low, but also the head of rivet is easy to crack because of too many hammer strikes. Press the button after pressing the rivet firmly against the punch. Otherwise, the reciprocating movement of the piston, will consume part of the energy, impact the piston shell, so that the rivet nut gun damage. The protection spring is used to make the punch and the gun body connected smoothly, so as to avoid the punch flying out and damaging people or products. Hold the handle with your right hand and press the button with your index finger to activate the rivet nut gun. The button can be used to adjust the size of the compressed air to ensure the stable operation of the rivet nut gun. In the early stage of riveting, due to the long rivet rod, the gap between the rivet rod and the rivet hole is large, the rivet rod is prone to bend when hammered. Therefore, the power of the rivet nut gun should be reduced by gently pressing the button. When the rivet rod is filled into the rivet hole and pressed again, the power of the rivet nut should be increased to quickly form the pier head. When the rivet nut head is close to the end head, the button should be gradually relaxed to avoid hitting the head too low. According to different types of rivet nut gun configuration, should not be used in series, so as not to damage mechanical parts, reduce efficiency.