Rose riveting nut has the following advantages:

Rose riveting nut has the following advantages:

Due to the use of special toughness steel, the use of professional tools from inside to outside the expansion rivet nut installed in the plate hole, strong assembly, not easy to fall off, simple assembly process; In order to further ensure that the rivet nut does not slide, many manufacturers use the gear method; Raw materials are free cutting iron or free cutting stainless steel. Free cutting iron or stainless steel.

Riveting nut column bottom hole, riveting nut, also known as riveting nut column or nut column, is a kind of fasteners, apply to the plate, plate, chassis, cabinets, hexagonal side between the cylinder and a groove, after internal thread for the internal thread, hex head through the press sheet into the preset hole (preset hole aperture is usually slightly larger than riveting nut column diameter), The plastic deformation is generated around the hole, and the deformation part is squeezed into the expansion groove of the rivet nut, and the rivet nut column is riveted to form an internal thread on the plate, and the internal thread is effectively fixed on the plate. Rivet nut column can be divided into four types, namely fast cutting steel through hole rivet nut column type, stainless steel through hole rivet nut column type, fast cutting steel blind hole rivet nut column type and stainless steel blind hole rivet nut column type, in the selection of nuts, the hardness of low carbon steel plate must be less than 70Rb, stainless steel plate hardness must be less than 80Rb.

Free cutting iron surface treatment, stainless steel to keep the original color, users can order according to phenotype specifications, also can be customized according to the need. Hole dimensions must be machined to tolerance dimensions 0-+ 0.075mm. It is recommended to drill holes in the steel plate. Installation must be through the "pressure riveting" operation to achieve, do not hit. If the material is stainless steel, the end number will be marked with an "S". The end face of the nut column is "C" for straight teeth. Through hole nut column length less than 10 mm is full wire, hexagonal end face (type I) or circular end face (type II) can be extended to 10 mm or more